Solar Rope Lights - CK-06

Solar rope lights:

CONTENTS:

1). Solar panel with LED rope strand 1pcs

2). Ground tube 1pcs

3). Pointed ground stake 1pcs

4). Wall mounting bracket 1pcs

5). Screw and drywall anchor 2pcs

6). Cable tie 3pcs

INSTALLATION

Your solar light panel must be installed in a sunny location where it will receive maximum sunlight during daytime hours. Any cover that shades the solar panel will affect its ability to absorb sunlight and decrease the amount of brightness and duration of the LED light.

The selected location should not be near a night time light source such as porch light, street light, etc., as this light may prevent the solar light from automatically turning on.

The solar panel can be positioned in the ground with the tube and pointed stake or a flat surface with the wall mounting bracket. The stake should be pushed into the ground until it is firmly in place. If the ground is too hard, soak the area with water to soften it. Once the tube and stake is in place, attach the solar panel. If you wish to attach the solar panel to a flat surface, use two of the provided screws to fasten the wall mounting bracket to an appropriate surface, drywall anchors are provided. Once the wall mounting bracket is in place, attach the solar panel. Be sure the solar panel is pointed towards sun. At least 8 hours of exposure to sunlight is required to illuminate the light strand.

Solar power light can be used to decorate tree, shrubs or highlight roofline and eaves

OPERATION

Switch the button to ON & charge battery for at least 8 hours before first time use.

FUNCTION

Mode selection-the light will function in two different ways:

1). Press the “ON/OFF” button once, Light will be in steady on mode

2). Press the “ON/OFF” button twice, Light will be in flashing mode.

3). Press the “ON/OFF” button third time to turn light off.

BATTERYCHARGING

If your lights begin to illuminate dimly or stays lit for shorter periods of time, you should replace the rechargeable batteries in the following way:

1). Unscrew the base plate from solar panel

2). Replace the old batteries with new one.

WARNING:

1). Be sure that battery polarity is correct. Use only rechargeable batteries.

2). Dispose of old batteries responsibly