LCD Display Digital Ballast with a remote control - RP019A

1.A LCD Display on the ballast show the Output Power, ON/OFF Time, Local Time, Start Time,.

2.Output Power: User can define this according to their Special requirement, Continuous from 110%to 40%.such like: Increasing or decreasing the output power by every 20 Watt or 50Watt:1100W—1080W…1000W…620W—600W--…400W, or

1100W—1050W-1000W--..650W—600W--..400W.

3.ON/OFF Time: Different Program have been installed in the ballast for ON/OFF Time, user can choose different program according to their requirement: 12/12,14/10, 16/8,18/6,20/4,22/2, 10/14,8/16,6/18,4/20,2/22.

4.Start time: When set this at 6:00 a. m., then everyday, the ballast will start at 6:00 am, and they will shut off according to ON/OFF Time Setting, such like: start time is 6:00 am, and ON/OFF Time is 12/12, then ballast will shut off at 6:00pm.

5.All these parameter can be controlled by a remote control, or set them on the ballast by hand.

6.Full Protection: Short/Open Circuit, Over/under Voltage, EOL, Surge Protection between Phase and Neutral, and between ground and line.

7.Thermal Management: Max case temperature: 85°C.When case temperature rise above 80°C,the ballast gradually reduce the power to the min output power(40%--50%),in order to reduce the heat. When the temperature is more than 85°C, the ballast will be in Over temperature situation and will shut off automatically. When the temperature falls to 80°C,the ballast will return to the previous power stage(the output power before the high temperature).

8.Staggered Ignition Time:When multiple ballasts are connected to the same main circuit, our Staggered Ignition software will completely balance the electrical draw by igniting one lamp at a time to prevent the electrical surges and spikes that can overload the main circuit.