24V 8W Super brightness LED panel for advertising display - SL-BL007-A080

Super brightness LED panel for advertising display

Product description

* Backlight panel using a unique honeycomb structure design to make full use of the view of the chips, to achieve uniformlight efficiency. There are no dark areas. And adhering to the design concept of the ultra-thin light box, we make your light box thinner and lighter, more beautiful and also easier connection.

* Dimming backlight panels can be customized to adapt to different occasions: bright, warm, soft ... controlled by you as you like, to improve the customer experience, and more energy-efficient.

* Backlight panels of different models can be combined freely, to show the size and shape, and is no longer limited.The backlit module is also available for any bigger size of light box.

* Backlight panels used imported LED chip, which have up to 35000H long lifespan, so you don’t need to replace lamps frequantly any longer. This can greatly save your light source acquisition costs and the cost of electricity.

Standard Accessories

1. flat head screw: 8PCS 2. Screw:4PCS

3. E-connector:4PCS 4. Insulation pad:4PCS

Optional Accessories

IR CONTROLLER

Power supply

LED Backlight

1.Non-mechanical compression on the LED light board and its components,

2. To prevent lamp beams don’t work, pls Protect the PCB light board during installation,

3.,Meet the requirements and safety standards of electronic components before installing LED light board (in the case of live work), to prevent short circuits pls don’t live operation,

4. Directly input DC/AC24V power when there is no dimming remote. If it is installed with dimming remote, connect input terminal of the remote control with output DC24V of the power supply , then connect output terminal of the remote control with the circuit board, as shown above single dimming connection, and then dimming and control can works.

5. When install a large area, the PCB board should be put in the same direction, guarantee the PCB board positive+ to positive+, and negative- to negative-. Then connect the PCB board with E-type gaskets and lock with screws, Maximum 40 pcs(2w) per circuit, more than 40 pcs(2w) pls divide them in another one circuit.

6. Input voltage of every PCB board is DC24V, and can’t input AC220V directly. The power of 7.5x30cm board is 2W, PLS noted that connect input DC24V + of power supply with PCB board+, and connect input DC24V- of power supply with PCB board - , reversed connection is very dangerous and not allowed..

7. When install a large area, pls pay attention the maximum power of the power supply and uniform distribution of each circuit. EX.150W 24V power supply can supply maximum 72pcs 7.5X30CM light board (2W),

More detail about installation pls feel free to contact with us.

Product application

♥ Contact:Polly

Tel:0086-5786516

MB:13696903705

Web:www.sunlitcn.com

Skype:baojing.xu